1. Connect ethernet from WAN port on Mini VPN router to another switch/router which has an internet connection
2. Connect power
3. Connect ethernet cable from the LAN port to your computer
4. Open a browser and go to https://192.168.3.1/
5. Login (the default password is the word 'none' without the quotes)
6. Then go to System > Backup / Flash Firmware
7. Hit perform reset button under Reset to Defaults
8. Disconnect the ethernet cable from the WAN port; then disconnect power
9. In the network manager on your computer edit the auto ethernet connection
10. Go to the IPv4 Settings tab and change the connection method from Automatic (DHCP) to manual
11. Then set the static IP to 192.168.10.122, netmask to 255.255.255.0, and gateway to 192.168.10.1; hit save
12. Reconnect power; give the router a few minutes to boot back up
13. Go to https://192.168.10.1 and if you get a LibreCMC login page the router has been successfully been reset
14. Login, no password required, then click System > Admistration and set password to none
15. Disconnect power on the router
16. In the network manager on your computer edit the auto ethernet connection
17. Go to the IPv4 Settings tab and change the connection method from manual back to Automatic (DHCP)
18. Reconnect power to the router
19. You should now get an IP address automatically when you connect to the router
Convert Mini VPN Router to a Non-VPN Configuration |